Stitching. basically, stitch and glue boats are constructed by gluing panels of plywood together using epoxy resin and fiberglass. the stitching is used to hold the panels in place while the glue is applied and allowed to cure.. The stitch and glue method uses wire sutures to hold panels together until they can be joined permanently with epoxy and fiberglass tape. the outside of the hull is completely coated with fiberglass or dynel cloth sheathing.. I basically stitched it with wire initially, then glued between the wires enough to "glue-stitch" it there. after 12 hours or so i pulled the wires and finished up the joints. never had any movement, never had any problems with wires not pulling out..
Fig. 22 stitch wires are pulled out by wobbling them back and forth, or clipped off and set beneath the surface. some use a soldering gun to heat the wire slightly.. The humble wire twister tool is a superb gadget for tightening the wire stitches holding your stitch and glue panels. this tool can be found on almost every farm. normally it is used to tie the necks of sacks, such as full potato sacks.. Stitch-and-glue boat building, along with the development of epoxy and modern mahogany marine plywood, has revolutionized and revitalized wooden boat building.. this method of boat building is not only stronger, lighter, and faster than traditional wooden boat building, but it also takes far less skill..
0 komentar:
Posting Komentar